Emergency lighting

Remote emergency systems

Remote emergency systems

With the constant development of low-energy compact fluorescent lamps, luminaire designers are now able to design smaller low profile luminaires. With the increasing requirements of emergency lighting in public buildings, these smaller luminaires can present problems where they are physically too small and hot to house integral emergency lighting control gear and batteries. For such applications, Projection Lighting offer a full range of pre-wired remote emergency control gear boxes which can be mounted adjacent to the luminaire and simply connected via a flexible 0.5 metre, flame retardant loom. Constructed in a galvanised finish steel enclosure without side panels for easy access.

If you require this service simply prefix the product with RB/

Product details

close window

Key Features:


  • Modules and PCB's are tested and approved to EN60924/EN60925. They are EMC compliant to EN55015 and carry the British Standard Kitemark and mark.
  • They incorporate over temperature and charger short circuit protection.
  • Mains supply 230v - 6% + 10% 50/60 Hz power consumption 8va (other supply voltages available on request).
  • Output circuitry uses a high efficiency sinusoidal inverter, with nominal operating current of 1 amp.
  • Available as standard in 3 hour operation (other durations to order).
  • All modules have battery deep discharge protection as standard (DDP) to prevent discharge below 1v per cell.
  • Reverse battery polarity protected.
  • All connections are via terminal blocks with a red light emitting diode (LED) to indicate correct charging conditions.
  • All products are supplied with red LED indicators, green LED can be supplied at no extra cost. Suffix catalogue number /GN.
  • Operating temperature range module 0°C to 70°C (centre side of case).
  • Printed circuit boards 0°C to 90°C (coil/core of charging transformer).